However, except at high Focus values, the Follow brush is pretty static: the brush's dots FOLLOW the mouse rather closely in a big cluster. ![]() The Follow brush can also create a floating Gauze effect. The billowing gauze image below was created with very similar settings as shown above, but a higher "Fade" value, which creates interesting naturalistic trails of cloth between two touchpoints. the creates a twisting billowing effect in the cloth which otherwise would hang down, pretty much like drapes. In the example below, the brushstroke on the left side has a Focus setting of "1", while the one on the right has a setting of "0". The tiny Focus value of "1" adds a little bit of slowly contracting oscillation back and forth around the mouse point. To adjust the Step value, unclick the Fill button temporarily, and the Step slider will become active. The Flame brush is basically a series of loops, and Step adds increasingly large gaps between the loops toward the tail of the brush. The image below makes use of a high Step value to get variation in the amount of complexity between areas of the fabric. These effects can be created with each of the three brushes (Flame, Follow and Ribbon), but since some of the effects only begin to appear at specific trigger values, it can take a lot of experimentation to find the best settings. Because of the physics simulation nature of Flame Painter, it is uniquely designed to create images that recall cloth blowing in the wind, gauze floating in water, knotted liquids, gauze pouring like liquid, and splashes of fabric!
0 Comments
Leave a Reply. |